Topic: HEAT AND LIGHT HOODWINKED

[Essabee]

I got too clever 4 years ago when I was building my all-glass 5’ 2’ 2’ tank. I needed to brace the longer sides at the top to avoid the water pressures from deforming or smashing the sides. I hate the cross braces as they interfere with tank maintenance. So I latched on to the idea of bracing the sides along its upper perimeter. I used 2 strips of glass for each side. I siliconed the first strip along the upper inner perimeter of the side and used the second strip as a laminate siliconed to the lower strip and the upper edge of the tank side. As for strengthening the tank sides were concerned it worked wonderfully well and the tank survives till date. As to making maintenance easier and unrestricted, that too worked wonderfully…………………….. The problem was not there and I found out that I had been too clever.

The 2” braces along the longer sides and the 3” braces along the shorter sides constitutes 26⅔ % of the total surface area of the tank. With a good coating of dust gathered over the years of use; these braces were restricting and absorbing more than quarter of the light over this planted tank. In fact these braces stole from me at least quarter of the electric charges I paid continuously for over 3 years for the lighting of this tank.

I need to change the hood and design a new one to solve this light restriction problem. Tell me how.

[Essabee]

Curtain raiser on my new hood for the 5 2 2 euro-braced tank.







Top of the hood is in two parts - the flat rear portion is the heat extractor chamber and the sloping front portion merely a reflector redirection for the lights.

I have placed the lights looking forward and needing redirection to the tank. Yes, I would loose an extra 10% of the light at-least by this arrangement as I am using a glossy white laminate for the reflector. I needed to arrange the lights in this way for two reasons - 1 because I like the lights to be directed on the inmates of the tank from the front as that displays them better, and 2 because I am using an odd mix of MH 70Wcoloured bulbs; two of the bulbs are blue and two are red all four are the type used for colouring fountains, the fifth bulb is a normal 5200K shop light which has a lot of green and yellow for brightness but is weak in either ends of the visible spectrum. The light arrangement is needed to mix the different shades before they enter the tank water for more uniform viewing.